Groove, point and gauge

A needle has one job: carry the thread through

Everything people argue about — sizes, points, systems, brands — comes back to that one sentence. The thread has to reach the far face of the cloth in the condition it set out in, and the cloth has to close up behind it.

A pale woven surface lit evenly from above
Folds of plain cream cloth in flat daylight

The groove, and what rides in it

Run a fingernail up the front of a needle and you will find a channel. While the blade is down in the cloth, the thread lies in that channel, and what rubs against the fabric is steel rather than thread.

Shelter is the whole point. Give a thread a groove too shallow for it and part of its width stands outside, and the weave files at that standing part on every stitch. The thread shreds, usually a few centimetres before the needle, and the thread gets the blame.

The opposite mistake is quieter. A blade much coarser than the thread needs leaves a hole wider than anything that has to fill it. On a close weave you can see where the needle went, and on a fine one the blade can push the cloth down into the plate as it goes.

What decides whether it fits

Point shape matters as much as the number

Two needles can be the same size across the blade and behave nothing alike, because the last millimetre is ground differently.

  • Cream cloth with an open, even weave photographed in soft daylight

    A sharp parts the weave

    A sharp point is ground to a cone and comes to a true tip. In a woven cloth it goes between two threads and pushes them aside, so the hole it makes is a gap in the grid rather than a cut. That is why a sharp is right for poplin, calico, denim and most linings — and why it is wrong for a jersey, where a true point will catch a loop and cut it.

  • A beige waffle knit photographed close up, the raised blocks catching the light

    A ball pushes the loops aside

    A ball point is rounded off instead of ground to a tip. On a knit there are no threads to part — there are loops, and anything sharp enough to pierce one will sooner or later sever it, which is how a ladder starts a week after the garment was made. The ball finds the gap between loops and pushes them out of the way instead.

Four questions asked over this counter

Answers as we give them over the counter, including the ones where the honest answer is that there is no number.

How do I know a needle is finished?

You usually do not, by looking. The tip rounds over by a few hundredths of a millimetre and that is enough to push the cloth instead of piercing it. The symptoms arrive first: skipped stitches, a thread that keeps breaking, a snagging noise, a pucker on fine cloth. Change the needle before you change anything else.

How long does one last?

We will not give you an hour figure, because it depends entirely on what you put it through: a synthetic lining with a dressing on it dulls a tip far faster than cotton calico. The honest rule is that a needle is a consumable and the packet is cheap.

Can I use a ball point on a woven cloth?

It will go through, but a ball point is made to push knitted loops aside rather than part threads, so on a close weave it drags the threads instead of separating them. On a loose weave you will not notice. On a tight poplin you will.

What does the second number mean?

Most packets carry two: a metric size, which is the blade across in hundredths of a millimetre, and an older imperial number beside it. They say the same thing twice. The metric number is the one this counter works in.

Three off the needle shelf

All sixteen on the wall
A pale linen weave photographed close upDomestic needles

130/705 H Sharp

€2.60

Five to a packet, one size

Folds of grey knitted jerseyDomestic needles

130/705 H Ballpoint

€2.90

Five to a packet, one size

Cones of thread on steel shelving in a store roomDomestic needles

ELx705 Overlock

€3.60

Five to a packet, one size